MiniRAE 3000 User’s Guide
90
To install the adapter in the instrument:
1. Remove the Li-ion battery pack from the battery compartment
by sliding the tab and tilting out the battery.
2. Replace it with the alkaline battery adapter
3. Slide the tab back into place to secure the battery adapter.
IMPORTANT!
Alkaline batteries cannot be recharged. The instrument’s internal circuit
detects alkaline batteries and will not allow recharging. If you place the
instrument in its cradle, the alkaline battery will not be recharged. The
internal charging circuit is designed to prevent damage to alkaline
batteries and the charging circuit when alkaline batteries are installed
inside the instrument.
Note: When replacing alkaline batteries, dispose of old ones properly.
WARNING!
To reduce the risk of ignition of hazardous atmospheres, recharge the
battery only in areas known to be non-hazardous. Remove and replace
the battery only in areas known to be non-hazardous.
Note: The internal charging circuit is designed to prevent charging to
alkaline batteries.
To Next Page
