MiniRAE 3000 User’s Guide
71
Power On Zero
When Power On Zero is on, the instrument performs a zero calibration
when it is turned on.
1. Press [N/-] to step from one option to the next.
2. Press [Y/+] to make your selection (the dark circle in the “radio
button” indicates your selection).
3. When you have completed your selection, press [MODE].
• Press [Y/+] to save the change.
• Press [N/-] to discard the change and move to the next sub-
menu.
Unit ID
This three-digit number keeps data separated by instrument when more
than one instrument is used in a network. If multiple sensing units are
attempting to communicate with the same Host, then the units must all
have a different Unit ID.
1. Press [Y/+] to step through all 10 numerals (0 to 9). If you pass the
numeral you want, keep pressing [Y/+]. After it counts up to 9, it
starts counting up from 0 again.
2. Press [N/-] to advance to the next digit. The next digit to the right
flashes.
Repeat this process until all three digits of the Unit ID are entered.
3. Press [MODE] when you are done.
• Press [Y/+] to save the change.
• Press [N/-] to discard the change and move to the next sub-
menu.
To Next Page
Loading...
