Rae MiniRAE 3000 - Data Selection

113 pages

Save Page as PDF

To Next Page

To Previous Page

MiniRAE 3000 User’s Guide

Pressing [N/-] steps you from screen to screen. Options include clearing

the Peak value and turning on the instrument’s PC Communications for

data transfer to a PC.

Main Page

Table of Contents3
Standard Contents11
General Information11
Physical Description13
Specifications13
Replacing Alkaline Batteries16
Charging a Lithium-Ion Battery18
- Charging a Spare Battery20
- Low Voltage Warning20
- Clock Battery21
- Data Protection While Power Is off21
User Interface22
- Display24
Operating the Instrument25
- Turning the Instrument on (Simple)25
- Turning the Instrument on (Power on Zero)26
- Turning the Instrument off26
- Operating the Built-In Flashlight26
- Pump Status27
- Calibration Status28
Operating Modes29
Compound-Specific Operation33
- Compound-Specific Measurement33
- Measurement Phases33
- Performing a Measurement33
- Separation Tube Preparation34
- Inserting the Separation Tube36
- Measuring37
VOC Operation40
- Basic User Level/Hygiene Mode (Default Settings)40
Alarm Signals43
- Alarm Signal Summary44
- Preset Alarm Limits & Calibration45
- Testing the Alarm45
Integrated Sampling Pump45
Backlight46
- Datalogging46
- Datalogging Event46
- Datalogging Sample46
- Auto/Manual/Snapshot Datalogging47
Accessories47
Standard Kit & Accessories48
- AC Adapter (Battery Charger)48
- External Filter49
Optional Accessories50
- Calibration Adapter50
- Calibration Regulator50
- Organic Vapor Zeroing Kit50
Standard Two-Point Calibration (Zero & Span)51
- Entering Calibration52
- Zero (Fresh Air) Calibration53
- Span Calibration54
- Exiting Two-Point Calibration in Basic User Level57
Three-Point Calibration58
- Span 2 Calibration60
- Exiting Three-Point Calibration61
Programming Mode62
- Entering Programming Mode62
Programming Mode Menus63
- Exiting Programming Mode65
- Navigating Programming Mode Menus65
- Calibration66
  - Zero Calibration66
  - Span Calibration66
- Measurement67
- Alarm Setting70
- Monitor Setup80
Humidity Compensation89
Hygiene Mode89
- Basic User Level & Hygiene Mode90
- Entering Search Mode from Hygiene Mode92
- Optional Graphic Screen in Search Mode93
Advanced User Level (Hygiene Mode or Search Mode)94
- Advanced User Level & Hygiene Mode94
- Basic User Level & Search Mode96
- Advanced User Level & Search Mode98
- Diagnostic Mode99
- Downloading the Datalog to a PC104
- Uploading Firmware to the Instrument from a PC105
Maintenance106
- Battery Charging & Replacement106
  - Replacing the Li-Ion Battery107
  - Replacing the Alkaline Battery Adapter107
- PID Sensor & Lamp Cleaning/Replacement109
- Cleaning the PID Sensor110
- Special Servicing Note113
Troubleshooting114
Technical Support115
RAE Systems Contacts116
Controlled Part of Manual119
Charging the Battery123

Rae MiniRAE 3000 - Data Selection

Table of Contents

Other manuals for Rae MiniRAE 3000

Related product manuals