Need help?Do you have a question about the Rain Bird HP 8 and is the answer not in the manual?
General| Brand | Rain Bird |
|---|---|
| Model | HP 8 |
| Category | Controller |
| Language | English |
Details the primary features of the HP Series controllers, including the LCD display and mechanical interface.
Covers dual programming, variable day-cycles, model sizes, and water budgeting capabilities.
Explains multiple start times, trickle charging, default programs, master valve control, and diagnostic circuit breaker.
Guide to setting the current time and selecting the day cycle using DIP switches.
Instructions for setting watering days and defining multiple start times for programs.
Assigning stations to programs, setting run times, and completing the programming setup.
Covers system off, water budgeting, manual station/cycle operations, and electrical fault display.
Guidance on selecting a suitable location and physically mounting the controller on a wall.
Instructions for connecting a 9-volt NiCad rechargeable battery to the controller's compartment.
Details on connecting station wires, common wire, and pump start/master valve wire to the terminal strip.
Instructions for connecting the controller's power supply, ensuring AC power is off during installation.
Specific wiring diagrams and procedures for international HP Series models using 220-260V, 50Hz power.
Information on potential electrical surges, built-in protection, and recommendations for added lightning protection.
Provides practical advice on watering frequency, duration, and methods for water conservation.
To Next Page
