RainPoint TWG009BW - Page 26

5. The water
inlet
leakage
1. No lter or not be
placed horizontally
2. The faucet is not the
Right standard 3/4"
1. Add lter and make
sure it's placed
horizontally in the inlet.
2. Make sure the faucet is
a 3/4" faucet.
3. Strengthen it with Seal
tape.
Issue Possible Cause Advice
4. Plan not
executed
on time
1. There are impurities
in the water inlet
lter.
2. Set rain delay
parameter.
3. Preset automatic
mode to close the
valve automatically
when it rains.
4. In low power state,
timer goes into low
power protection
state and does not
execute schedule.
5. No parameters are
set for irrigation
time/period.
1. Inlet impurities need
to be cleared regularly
so that they do not
clog up and inteere
with the irrigation
programme.
2. Check that the rain
delay parameter is set.
3. Check that the
parameters for
automatic mode rain
are set.
4. Replace the batteries
with new ones.
5. Check that the
irrigation time/period
is parameterized.
- 23 -