Linking And Unlinking The Remote Keyless Entry Key Fob To Memory
Your RKE Key Fobs can be programmed to recall one of two pre-programmed memory
profiles by pushing the UNLOCK button on the RKE Key Fob.
NOTE:
Before programming your RKE Key Fobs to memory the feature has to be selected.
• If your vehicle is equipped with a touchscreen, you must select the “Memory To
Fob” feature through the Uconnect system. Refer to “Uconnect Settings ” in
“Understanding Your Instrument Panel” in the Owner’s Manual on the DVD for
further information.
• If your vehicle is not equipped with a touchscreen, you must select the “Key Fob
Linked To Memory” feature through the Electronic Vehicle Information Center
(EVIC) or Driver Information Display (DID). Refer to “Electronic Vehicle Informa-
tion Center (EVIC)” or “Driver Information Display (DID)” in “Understanding Your
Instrument Panel” in the Owner’s Manual on the DVD for further information.
To program your RKE Key Fobs, perform the following:
1. Cycle the vehicles ignition to the Off position.
2. Select desired memory profile (1) or (2).
NOTE:
If a memory profile has not already been set, refer to "Programming The Memory
Feature" for instructions on how to set a memory profile.
3. Once the profile has been recalled, push and release the SET (S) button on the
memory switch, then push and release button (1) or (2) accordingly. “Memory
Profile Set” (1 or 2) will display in the instrument cluster on vehicles equipped
with the EVIC/DID.
4. Push and release the LOCK button on the RKE Key Fob within 10 seconds.
NOTE:
Your RKE Key Fobs can be unlinked to your memory settings by pushing the SET (S)
button, and within 10 seconds, followed by pushing the UNLOCK button on the RKE
Key Fob.
GETTING STARTED
35
To Next Page
Loading...
