RAM 3500 - Page 38

Memory Position Recall
NOTE:
• For vehicles equipped with an automatic transmission, the vehicle must be in
PARK to recall memory positions. If a recall is attempted when the vehicle is not
in PARK, a message will be displayed in the Electronic Vehicle Information Center
(EVIC) or Driver Information Display (DID).
• For vehicles equipped with a manual transmission, the vehicle speed must be at
0 mph (0 km/h) to recall memory positions. If a recall is attempted with the
vehicle speed above 0 mph (0 km/h), a message will display in the EVIC/DID.
Driver One Memory Position Recall
• To recall the memory settings for driver one using the memory switch, push
MEMORY button number 1 on the memory switch.
• To recall the memory settings for driver one using the RKE Key Fob, push the
UNLOCK button on the RKE Key Fob linked to memory position 1.
Driver Two Memory Position Recall
• To recall the memory setting for driver two using the memory switch, push
MEMORY button number 2 on the memory switch.
• To recall the memory settings for driver two using the RKE Key Fob, push the
UNLOCK button on the RKE Key Fob linked to memory position 2.
A recall can be cancelled by pushing any of the MEMORY buttons during a recall (S,
1, or 2). When a recall is cancelled, the driver's seat, and the power pedals (if
equipped) stop moving. A delay of one second will occur before another recall can be
selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat positioning to enhance driver mobility
when entering and exiting the vehicle.
The distance the driver seat moves depends on where you have the driver seat
positioned when you remove the Key Fob from the ignition (or change the ignition to
OFF, for vehicles equipped with Keyless Enter-N-Go).
• When you remove the Key Fob from the ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-Go), the driver seat will move about
2.4 inches (60 mm) rearward if the driver seat position is greater than or equal to
2.7 inches (67.7 mm) forward of the rear stop. The seat will return to its previously
set position when you place the ignition into the ACC or RUN position.
• When you remove the Key Fob from the ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-Go), the driver seat will move to a position
0.3 inches (7.7 mm) forward of the rear stop if the driver seat position is between
0.9 inches and 2.7 inches (22.7 mm and 67.7 mm) forward of the rear stop. The
seat will return to its previously set position when you place the ignition to the ACC
or RUN position.
GETTING STARTED
36