RAMMER S 83 STD - Hammer Tool Greasing

To Next Page

To Previous Page

Hammer tool greasing S 83 STD

1. HAMMER TOOL GREASING

1.1 RECOMMENDED GREASES

■ RAMMER TOOL GREASE, part no. 902045

■ FUCHS Meisselpaste

■ KENDALL Tough TAC

■ KLÜBER Crafloscon C-SG 0 Ultra

■ LE 3751/3752 Almagard varipurpose lubricant

■ SHELL Kuggfett

■ SHELL Albida HLS 2

■ WYNNS GS80

1.2 MANUAL GREASING

Follow the product's greasing instructions and avoid excessive greasing. Dis-

pose of empty grease containers appropriately.

GREASING INTERVAL

1. Tool shank must be well lubricated before installing tool.

2. 5-10 strokes from grease gun to tool bushings and tool at regular intervals.

3. Adapt interval and amount of grease to wear rate of tool and working condi-

tions. This can be anything between two hours and daily, depending on material

(rock/concrete) to be broken. See “Recommended greases” on page 32.

Insufficient greasing or improper grease may cause:

■ Abnormal wear of tool bushing and tool

■ Tool breakage