To Next Page

To Previous Page

Operating concepts

R&S

NRP Series

43Getting Started 1419.0170.02 ─ 16

3. Configure the measurement.

a) In the "Measurement Settings" dialog, select the "Measurement Type", for

example "Continuous Average".

b) Tap "Quick Setup" > "Auto Set".

4. Switch on the signal source.

The measurement starts, and the result is displayed in dBm.

5. If necessary, perform further settings.

R&S NRX

Other manuals for R&S NRP Series

Questions and Answers:

Need help?

Do you have a question about the R&S NRP Series and is the answer not in the manual?

General