R&S XU 4200 - RSSI Output Characteristic; Introduction;Overview; Fig. 3.80 RSSI Output Type − R&S Standard

R&S XU 4200 RSSI Output Characteristic
6166.5368.02.01 3.84
3.9 RSSI Output Characteristic
0.
RSSI Output Conf iguratio n\RSSI Output Co nfigurati on "Radio".doc
This chapter
This chapter provides information about the characteristic and configuration
of the analog RSSI output on the radio.
3.9.1 Introduction/Overview
Introduction
The received signal strength indication (RSSI) is available as an analog
voltage via the RSSI output on the rear side of the radio (X11.8).
The R&S Series 4200 radios support a configurable analog RSSI output.
RSSI Output Type
The RSSI output characteristic can be configured with the “RSSI Output”
parameter in two different modes:
 “R&S Standard” type with a linear dependency of the received signal
strength predefined by the manufacturer (see Fig. 3.80 RSSI
output type  R&S Standard)

“User defined” type with variable u
ser defined parameter settings to
adapt the radio behavior to customer’s needs (see Fig. 3.81 RSSI
output type  User defined)
R&S Standard
The
RSSI output type “R&S Standard” has a linear characteristic with the
slope of 38.5 mV/dB and offset of 4620 mV @ 0 dBm.
Fig. 3.80 RSSI output type − R&S Standard.