R&S XU 4200 - 2 Preparation for Use; Safety Precautions

Safety Precautions R&S XU 4200
6166.5368.02.01
2.1
2 Preparation for Use
This chapter
This chapter provides all information for:
 Checking upon delivery
 Installation into a 19" rack
 Connection of peripheral equipment
 Connection of mains and/or 28 V DC supply
Further
information
Chapter 3.1 contains an overview of the
transceiver control elements,
indicators, etc.
Cha
pter 6.2 is an in-depth description of the radio’s interfaces.
2.1 Safety Precautions
Safety Prec autions\Saf ety Precaut ions"Radio ".doc
ATTENTION
Before putting the transceiver into operation, make the following checks:
 Ensure that the ventilation holes are free of obstructions.
 Ensure that there are no unsuitable signal voltages connected to the
input.
 The transceiver’s outputs may not be overloaded and correct polarity
must be ensured.
The radio may be damaged if the above checks are not performed.
ATTENTION
When fitting operating rooms and installing and operating electrical
equipment, the relevant national and international safety provisions and
regulations have to be adhered to.
The following safety instructions apply in particular:
 IEC 364
 VDE 0100
 DIN 57100
These safety regulations deal with the following subjects:
 Protective measures:
- Prevention of accidents
- Overvoltage protection
- Insulation of equipment
- Grounding
 Type and laying of lines and cables
 Provisions for operational facilities, rooms and equipment requiring
special handling
Note: Electrostatic discharge (ESD) can cause temporary malfunctioning of
the display, resulting in the deletion of the on-screen contents. This
malfunction can be eliminated by restarting the radio. ESD discharges will
not impair other functional features of the radio.