R&S XU 4200 - Fig. 2.3 Rear Cabling

R&S XU 4200 Basis Cabling
6166.5368.02.01 2.6
Note: The DC input/battery input (X2) of the radio is intended for a DC-only
supply of the radio or connection of the external backup battery stacks for
bridging interruptions of an AC supply of the radio. Rohde & Schwarz
recommends using DC cables with a length of < 3 m and an appropriate
wire gauge.
Note: Do not connect/disconnect any cable when the radio is operating.
Connect all other cables before the radio is connected to AC and/or DC
power.
Rear Cabling\ Rear cabl ing "Radio".do c
Fig. 2.3 Rear cabling.
8.
1.
2.
3
.
4.
5.
9.
7.
6
.
3.