R&S XU 4200 Software Download
6166.5368.02.01 3.112
3.16 Software Download
Software Download\Software Download "Radio".doc
Introduction
The software download can be done using the Service and Maintenance
Tool R&S ZS4200. There is a possibility to perform the software download
remotely via the LAN interface (see Fig. 3.97) or by using the local USB
interface (see
Fig. 3.98).
Note: For de
tails (e.g. IP address), please refer to the Service and
Maintenance Tool R&S ZS4200 software manual.
Fig. 3.97 Software download via LAN.
Fig. 3.98 Software download via USB.
Partition
management
The radio is equipped with two different partitions; each of them can be
updated with a certain software version. The software versions in a partition
1 may be different from the version in a partition 2.
The radio may be booted from each partition. The partition to be booted can
be selected with the LAN command “RU_SI” or by using the
Service and Maintenance Tool R&S ZS 4200. For more details, see the
Service and Maintenance Tool R&S ZS 4200 software manual and the ICD.
Note: As the R&S XU 4200 contains 3 modules (receiver, transmitter and
MMI modules), there is a partition 1 and a partition 2 in each module.
To Next Page
Loading...