Command reference
R&S
®
ZNA
1355User Manual 1178.6462.02 ─ 20
Parameters:
<Temperature> Ambient temperature in Kelvin.
Example:
SENSe1:NFIGure:TEATtenuator 320
Options: R&S ZNA-K30
Manual operation: See "General > Ambient Temperature" on page 329
7.3.14.18 [SENSe:]PATH...
Settings for the optional Direct generator/receiver access and Chapter 4.7.29, "Direct
IF access", on page 278.
[SENSe<Ch>:]P
A
TH<Pt>:DIRectaccess
......................................................................... 1355[SENSe<Ch>:]P
A
TH<Pt>:IFINpath
.................................................................................1356[SENSe<Ch>:]P
A
TH<Pt>:IFOutauto
...............................................................................1356[SENSe<Ch>:]P
A
TH<Pt>:IFRequency
............................................................................1357[SENSe<Ch>:]P
A
TH<Pt>:IFSWitch
................................................................................1358[SENSe<Ch>:]P
A
TH<Pt>:MEASurement:DIRectaccess?
................................................. 1358[SENSe<Ch>:]P
A
TH<Pt>:REFerence:DIRectaccess?
...................................................... 1358[SENSe<Ch>:]P
A
TH<Pt>:MEASurement:IFINpath?
.........................................................1359[SENSe<Ch>:]P
A
TH<Pt>:REFerence:IFINpath?
..............................................................1359[SENSe<Ch>:]P
A
TH<Pt>:MEASurement:IFOutauto?
.......................................................1359[SENSe<Ch>:]P
A
TH<Pt>:REFerence:IFOutauto?
............................................................1359[SENSe<Ch>:]P
A
TH<Pt>:MEASurement:IFRequency?
....................................................1359[SENSe<Ch>:]P
A
TH<Pt>:REFerence:IFRequency?
.........................................................1359[SENSe<Ch>:]P
A
TH<Pt>:MEASurement:IFSWitch?
........................................................ 1360[SENSe<Ch>:]P
A
TH<Pt>:REFerence:IFSWitch?
.............................................................1360[SENSe<Ch>:]P
A
TH<Pt>:DIRectaccess
<path>Defines the direct generator/receiver access path.
Same functionality as SOURce<Ch>:PATH<Pt>:DIRectaccess
Note that direct generator/receiver access and direct IF input cannot be used at the
same time. Direct generator/receiver access is only used if [SENSe<Ch>:
]PATH<Pt>:IFSWitch is set to OFF or OUT.
Suffix:
<Ch>
.
Channel number
<Pt> Port number
Setting parameters:
<path> NONE | B16 | REV | SRC
NONE
Direct generator/receiver access not used (Out/In pairs jum-
pered)
B16
Standard use of direct generator/receiver access
SCPI command reference
To Next Page
Loading...
