What to do if Ethernet Link LED indicators do not come on for Rane Computer Hardware?
If the Ethernet Link LED indicators on your Rane Computer Hardware do not light up after connecting the HAL Ethernet cable, the cable might be broken. Try using a different cable. Alternatively, the port on the network switch may not be working; try plugging the cable into a different port on the network switch.
What to do if HAL and/or network switch isn’t powered on for Rane HAL1x Computer Hardware?
If your Rane Computer Hardware isn't functioning, make sure that both the HAL and the network switch are powered on.
How to prevent excessive voltage drop between HAL and RAD on Rane Computer Hardware?
If you suspect an excessive voltage drop between the HAL and RAD with your Rane Computer Hardware, verify the cable length from the HAL to RAD has not exceeded 150 meters.
How to fix excessive voltage drop between HAL and DR on Rane HAL1x?
If you are experiencing voltage drop issues between the HAL and DR on your Rane Computer Hardware, verify that the cable length from HAL to DR has not exceeded 150 meters.
What to do if the HAL is not powered on Rane HAL1x?
To resolve power issues with your Rane Computer Hardware, power on the HAL and wait for it to boot up.
How to troubleshoot a mis-wired cable disrupting power to the RAD in Rane HAL1x?
If a mis-wired or broken cable is disrupting power to the RAD in your Rane Computer Hardware setup, use a cable tester to verify wiring of the shielded CAT 5e cable.
How to check twisted pair wiring in Rane Computer Hardware?
If the twisted pair in the shielded CAT 5e cable carrying communications data is miswired or broken in your Rane Computer Hardware, use a cable tester to verify wiring of the shielded CAT 5e cable.
How to fix a mis-wired cable disrupting power to the DR in Rane HAL1x Computer Hardware?
If a mis-wired or broken cable is disrupting power to the DR in your Rane Computer Hardware setup, use a cable tester to verify shielded CAT 5e termination.
What to do if twisted pair cable is miswired or broken in Rane Computer Hardware?
If the twisted pair in the shielded CAT 5e cable that carries communications data is miswired or broken for your Rane Computer Hardware, use a cable tester to verify the wiring of the shielded CAT 5e cable.
What to check if RAD is not receiving audio from HAL on Rane HAL1x Computer Hardware?
If the RAD is not receiving an audio stream from the HAL in your Rane Computer Hardware setup, and you are using a punch block, verify that the green pair is properly punched (assuming T568B termination).
General| A/D Converters | 24-bit |
|---|---|
| D/A Converters | 24-bit |
| Sample Rate | 48 kHz |
| Bit Depth | 24-bit |
| Driver | ASIO, Core Audio |
| Connectivity | Ethernet |
| Connection Type | USB |
| Phantom Power | Yes |
To Next Page
