How to troubleshoot HAL not receiving audio stream from RAD on Rane HAL1x?
If the HAL is not receiving an audio stream from the RAD in your Rane Computer Hardware setup, and you are using a punch block, verify that the blue pair is properly punched (assuming T568B termination).
What to do if DR is not receiving enough power on Rane HAL1x Computer Hardware?
If the DR is not receiving enough power with your Rane Computer Hardware, shorten the cable.
How to take DR out of Locate mode in Rane Computer Hardware?
To take the DR out of Locate mode in your Rane Computer Hardware setup, create or fix the control link in Halogen.
What to do if the display is blank on Rane Computer Hardware?
If the display is blank while the DR is connected to a live HAL for your Rane Computer Hardware, add the appropriate toggles, commands, or levels to this DR in Halogen.
General| A/D Converters | 24-bit |
|---|---|
| D/A Converters | 24-bit |
| Sample Rate | 48 kHz |
| Bit Depth | 24-bit |
| Driver | ASIO, Core Audio |
| Connectivity | Ethernet |
| Connection Type | USB |
| Phantom Power | Yes |
To Next Page
