11
2. Locate and align the mating marks on the Face Plate
and Shaft Assembly.
3. Be sure to tighten the bolt firmly. Step on the manual
brake to hold the shaft while tightening the bolt.
INSTALLING THE
OUTER GAUGE ARM
NOTE: This section only applies to the DST-64T models.
1. Locate the mounting arm for the outer gauge-arm.
2. Attach the mounting arm onto the hood switch box
using the 4 provided socket head cap screws.
3. Locate and unpack the outer gauge-arm.
4. Attach the outer gauge-arm to the mounting arm using
the provided socket head cap screw and washer.
5. Run the wire coming off the gauge-arm thru the clips
on the underside of the mounting arm.
6. Attach the end of the wire to the connection on the
back side of the balancer.
INITIAL START-UP
1. Turn the balancer ON/OFF switch to ON.
2. The LED Display will show BAL. 06
3. Mount a standard steel wheel (of a size most often
balanced).
4. Lower the Hood to check the activation of the
AUTO-HOOD START. The Main shaft should spin
when the hood is lowered.
5. The threaded main shaft should spin CLOCKWISE
when viewed straight on. If the faceplate spins
counterclockwise, turn the balancer off and consult
the factory.
AUTO HOOD ENABLE/DISABLE
1. To enable/ disable AUTO HOOD START feature press
and hold the STOP Button and then the C button.
To Next Page
Loading...
