12
ACTIVATING THE OUTER GAUGE ARM
NOTE: This section only applies to the DST-64T models.
To activate the Outer Gauge Arm, touch the external edge
of the wheel with the pointer.
If you suspect the arm is disabled or OFF and you do not
hear a beep when the pointer touches the rim, proceed to
the following steps:
1. Press C and D buttons at the same time and hold until
CAL- CAL-CAL shows in the Inner, Outer and Width
windows. Keep pressing until display stops blinking.
2. Press the Down Arrow below distance, then the
Up Arrow below distance, LED lights will go blank.
3. While lights are off, promptly, press the ALU button
and dF will show on the inner window.
4. Press the Distance UP Arrow, four times, until aut
shows on the inner window. (See below).
5. If the Width (middle screen) displays OFF, press the
Width Arrow UP to change it to ON. If the middle
screen displays ON, then the outer arm is already
enabled.
6. Press the Distance Up Arrow 3 times to advance to
the original start-up balancer screen.
Outer Gauge Arm
To Next Page
Loading...
