25
7. The wheel will spin briefly then stop.
8. ADD 100 / ADD 3.50 will be displayed on the side
marked INNER depending if program has been set to
grams or ounces. (See page 12).
9. Turn the wheel by hand until the weight position
indicator lights on the side marked INNER are fully
illuminated.
10. Place one 100-gram / 3.50-ounce weight (included with
balancer) at the 12 o’clock position on the INNER side
of wheel.
11. Close hood then press START button. The wheel will
spin briefly and stop.
12. ADD 100 / ADD 3.50 will again be displayed.
13. Remove the previously placed balancing weight.
14. Turn the wheel by hand until the weight position indicator
lights on the side marked OUTER are fully illuminated.
15. Replace weight at the 12 o’clock position on the OUTER
side of wheel.
16. Close hood then press START button. The wheel will
spin briefly and stop.
17. Remove and stow the special balancing weight.
18. END-CAL will be displayed. Calibration procedure is
complete.
NOTE: It is a good idea to keep the known good
“calibration standard 18” wheel/tire assembly” set up for
the monthly calibration procedure.
To Next Page
Loading...
Need help?
General
