Rangevision SPECTRUM - Select Scanning Zone

Selectingscanningzone
After preparatory actions on setting up the computer, you should carry the
scanner setting procedure. Select Configure scanner for a new area in
Calibration window on the Start screen and follow the instructions for each step.
Before beginning the configuration, select the desired scan area (zone), depending on
the object scanned. Scanning area is a set of interchangeable optics, calibration plate
and standforthecalibrationplate, which help toconfigurethescannertoscan a certain
area. Inthemajorityofcases, scan areaiscorrectlymatched,ifthesizeof the object
approximately equalstothe size calibrationplate.
12