Chapter 3: DX Series
23
Numbers Components
Dip switch 2 controls CC3.
Dip switch 3 controls CC4.
Dip switch 4 controls CC5.
Bottom row:
Dip switch 1 controls CC1.
Dip switch 2 controls the built in hall effect sensor.
Tip: If an alert is shown for this hall effect sensor, you can
disable it by turning on/off dip switch 2.
CC status LEDs. For details, see
DX2-CC2 Contact Closure
Sensor LEDs
(on page 16).
High-speed flashing of CC1 LED indicates that the DX
firmware upgrade is in progress. See
Sensor Firmware
Update
(on page 79).
Top row:
The four LEDs, from left to right, indicate the states of
CC2, CC3, CC4 and CC5 respectively.
Bottom row:
The LED indicates the CC1 state.
To Next Page
Loading...