Chapter 3: DX Series
31
Numbers Components
Dip switch 1 controls CC2.
Dip switch 2 controls CC3.
Bottom row:
Dip switch 1 controls CC1.
Note: Dip switches 3 and 4 in the top row and dip switch 2 in
the bottom row do not control any channel and can be
ignored.
CC status LEDs. For details, see
DX2-CC2 Contact Closure
Sensor LEDs
(on page 16).
High-speed flashing of CC1 LED indicates that the DX
firmware upgrade is in progress. See
Sensor Firmware
Update
(on page 79).
Top row:
The two leftmost LEDs, from left to right, indicate the
states of CC2 and CC3 respectively.
Note: The two rightmost LEDs in the top row are not
associated with any CC channels and can be ignored.
Bottom row:
The LED indicates the CC1 state.
To Next Page
Loading...