Chapter 3: DX Series
35
Important: For a PDC channel, you must check the electrical polarity
markings (+ and -) on the DX label to make sure each wire is
inserted into the correct termination point with the correct polarity.
3. Use a screwdriver with a 2.5 mm wide shaft to tighten the screws
above each termination point to secure the wires, using a torque of
0.196 N·m (2 kgf·cm).
To make connections after the terminal module is detached:
1. Loosen the screws at two sides of the terminal module.
Note: The two screws are not removable so just loosen them.
To Next Page
Loading...