Rational iCombi Pro XS 6-2/3 - Cleaning Modes; Cleaning Programmes; Cleaning and Care Status

15 | Automatic cleaning - iCareSystem
88 / 112 Operating instructions
n
If a care product gets into your eyes, rinse your eyes with running water for 15
minutes. Remove any contact lenses.
n
If you swallow a care product, rinse out your mouth with water and immediately
drink half a litre of water. Do not provoke vomiting.
n
Call the emergency poison helpline or a doctor.
15.2 Cleaning modes
The 2 following cleaning modes are available for the light, medium and strong cleaning programs:
Eco mode
If you select this cleaning mode, less care product will be required to clean the unit when using the cleaning
programs [}88]. The cleaning programmes will therefore run for longer than in the normal mode.
Normal mode
If you select this cleaning mode, more care product will be used to clean the unit when using the cleaning
programs [}88]. The cleaning programmes will therefore be shorter than in the Eco mode.
15.3 Cleaning programmes
The following cleaning programs are available:
Programme Mode Description Care product
Light Eco / Normal Suitable for removing light dirt and
scale resulting from use of the unit
at up to 200 °C.
n
Active Green cleaner
tabs
n
care tabs
medium Eco / Normal Suitable for removing dirt and
scale resulting from cooking
processes including grilling or
roasting.
n
Active Green cleaner
tablets
n
care tabs
heavy Eco / Normal Suitable for removing heavy dirt
and scale resulting from cooking
processes including grilling or
roasting.
n
Active Green cleaner
tablets
n
care tabs
Fast – Suitable for an interim cleaning to
quickly remove heavy soiling.
This cleaning program does not
reset the forced cleaning.
n
Active Green cleaner
tabs
Rinse w/o tabs – Suitable for removing water-
soluble dirt.
This cleaning program does not
reset the forced cleaning.
–
Rinsing – Suitable for removing calcium/
chalky dirt resulting from cooking
processes including baking or
steaming.
n
care tabs
TIP
If your cooking system is connected to soft water, you should set the soft water switch to “Soft water”.
15.4 Cleaning and care status
iCareSystem automatically detects the cleaning and care status of your unit.