Rational iVario Pro L - Programming Mode Operations; Programming the Shopping Cart

11 | Options
80.06.231_iVarioProL-iVarioProXL_IM_en-GB 59 / 72
1. Drill 2 holes in the base.
50 mm [2 Inch]
x
2. To seal the drill holes, use chemical dowels. Please note the instructions of
the manufacturer.
3. Place the unit on the base installation.
> The holes in the substructure and in the bottom of the base overlap one an-
other.
4. Unscrew the 2 screws and remove the cover of the base on each side.