CHAPTER 3
12 RoGator (Liquid/AirMax 180) & TerraGator (Liquid/AirMax/AirSpread) AccuBoom™ Installation Manual
FIGURE 4. Single and Double Node Mounting
1. Align the node mounting tabs with the holes on the mounting plate.
2. Secure the node to the mounting plate using the supplied hardware.
NOTE: If a SmarTrax node is present on the machine, stack the nodes so that the SmarTrax node is mounted
against the mounting plate.
3. Align the node mounting plate withe the mounting standoffs with the node connections facing the window of
the cab.
4. Fasten the mode mounting plate to the mounting standoffs using four M6 x 1” bolts and lock washers.
INSTALL THE ACCUBOOM WIRING
CAUTION
Always connect the power cable as the last step
in the wiring process and verify that the power
leads are connected with the correct polarity.
Reversing power leads can cause severe damage
to the equipment.
SmarTrax Node
AccuBoom Node
To Next Page
Loading...
