Raven AutoBoom - Page 6

Chapter 1
2 AutoBoom® Calibration & Operation Manual
•
When starting the machine for the first time after installing AutoBoom, be sure that all persons stand clear of
the vehicle in case a hose or fitting has not been properly tightened.
• The machine must remain stationary and switched off, with the booms unfolded and supported while
installation or maintenance on the hydraulic system is conducted.
Hydraulic Safety
• Raven Industries recommends that appropriate protective equipment be worn at all times when installing or
servicing the hydraulic system.
• Never attempt to open or work on a hydraulic system with the equipment running. Care should always be
taken when opening a system that has been previously pressurized.
• Hydraulic fluid may be extremely hot and under high pressure. Caution must be exercised when
disconnecting or purging hydraulic components.
• Any work performed on the hydraulic system must be done in accordance with the machine manufacturer’s
approved maintenance procedures.
• Take precautions to prevent any foreign material or contaminants from being introduced into the hydraulic
system when installing or maintaining the hydraulic components. Objects or materials that are able to
bypass the hydraulic filtration system will adversely reduce performance and possibly damage the
AutoBoom hydraulic valves.
Electrical Safety
• Disconnect the Raven OS device and all electrical components of the Raven system before jump-starting
the vehicle or welding on any component of the implement.
• Always verify that power leads are connected to the correct polarity as marked or instructed. Reversing the
power leads could cause severe damage to the equipment or components.
• Ensure that the power cable is the last cable to be connected.
WARNING
CAUTION