What causes the left, right, and center raise/ lower functions to be sensed incorrectly on Raven Farm Equipment?
R
Raymond BaxterSep 12, 2025
If the left, right, and center raise/lower functions are not sensed correctly when the machine manual functions are used, it is likely because the boom sense cables/connections are connected to the incorrect machine coils. Check the connections to the machine coils and trace the wiring to ensure the connections are made to the correct cylinders.
J
Joseph HarrisSep 13, 2025
What causes the center section of my Raven Farm Equipment to not raise/ lower manually?
D
David HobbsSep 13, 2025
If the center section will not raise/lower manually when the machine manual functions are used, it could be because the center rack boom sense cables are not connected to the correct center sense/control function. Check the connections to the machine coils and trace the wiring to ensure the connections are made to the correct coils. The AutoBoom node hardware may not support the center rack control function; the node must be revision ‘B’ or higher to support this function.
A
Ashley ProctorSep 14, 2025
How to resolve Raven Farm Equipment's inability to switch from PowerGlide Plus to UltraGlide mode?
E
ehigginsSep 14, 2025
If the system cannot be switched from PowerGlide Plus to UltraGlide mode, connect the sensor cables from the harness cable to the sensors, check the node cable connections, and repair or replace cables as necessary. If you have a non-dual sensor system, disconnect the sensors from the AutoBoom harness cable and connect the outer sensor connectors to the sensors. Verify an AutoBoom UltraGlide node is connected to the CANbus.
E
Edward McdonaldSep 17, 2025
Why fold/unfold status does not change when booms are folded/unfolded on Raven Farm Equipment?
J
Jodi ShawSep 17, 2025
If the fold/unfold status does not change when booms are folded/unfolded, check the electrical connections to the fold/unfold sensors.
To Next Page
General
