13
Field Markers
While a job is in progress, Field Markers may be added to locate things such
as well heads, rock piles or other points of interest. During the application,
Cruizer will display the distance between each marker and the current vehicle
location.
To place a field marker, touch the Marker at the bottom of the screen.
Cruizer will set a field marker at the current vehicle location.
Moving Markers
To move a marker, touch the base of the marker and select Move .
Touch the desired location for the marker to place the marker in the new
location.
Delete Markers
To delete a marker, touch the base of the marker and select Delete .
The marker will be removed.
Ending a Job
Use the following steps to end a Job:
1. Touch Menu Home End Job .
2. To save a report for the job, see the Coverage Maps section on page 18.
Powering Down the Cruizer
Use the following steps to power down and shut off the Cruizer. From the
Home Screen:
1. Touch the End Job icon if a job is in progress.
2. Select Shut Down and Accept .
3. Select the Accept icon again and toggle the power switch off.
To Next Page
Loading...
