Raven Cruizer - Cruizer Baud Rate Settings

19
Baud Rate Settings
Baud rate settings allow the Cruizer console to communicate with other
equipment such as steering, section control or DGPS systems or
components.
1. From the Home Screen, select:
Tools Menu GPS Output .
2. When connecting the products listed below, ensure that the appropriate
port is selected and all messages are set to zero.
3. Touch Baud Rates .
4. Use the following table to enter
the correct baud rate settings for
each port.
Product Port
SmartBoom/SmartRow A or B
TM-1 Tilt Sensor B
SmarTrax
(software version 4.1 or older)
B
Steering Node B
Product Port A Port B
TM-1 Tilt Sensor --------- 19200
SmarTrax
(software version 3.2 or older)
---------
38400
Recommended
SmarTrax
(software versions 4.0 or newer)
---------
115200
Recommended
Steering Node 115200 115200
SmartBoom/SmartRow
a
a.SmartBoom and SmartRow will forward the GGA and VTG
messages a 5 Hz when initializing the connection.
19200 19200