17
Display
During a job, the built-in light bar indicates the distance and direction to the
current guidance path.
1. From the Home Screen, select:
Tools Menu Computer Display .
2. Select the Day or Night mode for the Guidance Screen display.
3. Use the Lights and Screen sliders to adjust the brightness of the touch
screen and built-in light bar LED’s.
4. Adjust the Light Bar slider in the lower section of the Display screen to set
the light bar sensitivity. Select one of the following available sensitivities:
• Fine
• Medium
• Coarse
The lower-center green LED illuminates when receiving a DGPS signal.
The upper-center green LED illuminates when guidance is in progress and
the vehicle is on the currently displayed guidance path. See the Starting
Guidance section on page 6 to begin guidance.
If an optional SmarTrax system has been installed, the outside orange LEDs
will illuminate when the SmarTrax system is engaged.
To Next Page
Loading...
