Raven Cruizer - Cruizer Tools Menu; Cruizer System Settings

14
Tools Menu
Quick Access Bar
While viewing the Tools Menu, the Quick Access Bar remains at the top of
the screen and allows quick access to the Favorites, System, GPS,
Computer, and Vehicle menus. Touch the Show All icon to view all menus
within the Tools Menu.
The following pages offer descriptions of each menu found within the Tools
Menu.
System
Favorites Icon - Refer to the Favorites Menu section on page 16 to
set up the Favorites Menu.
Switch - Select the source for toggling history on or off. Install and
connect the optional external switch wire to a source of +12V power
to utilize the Hardware setting.
If Touch Screen is selected, touching or on the
Guidance Screen will toggle coverage history recording On or Off.
Tilt - The Tilt icon is only displayed if an optional TM-1 Tilt Module is
connected to the console. Select the Tilt icon to setup and calibrate
the TM-1 Tilt Module. Touch the Information icon for detailed
information for this feature.
Note: The Tilt option only appears if a TM-1 Tilt Module is connected.
The baud rate for Port B must be set to 19200 to allow Cruizer to
communicate with the TM-1. See the Baud Rate Settings section
on page 19 for information on other configurations with SmarTrax.