27
Lightbar Configuration
This screen allows you to configure the lightbar setup, as well as enable an
external lightbar and the tilt sensor.
1. From the ‘Configuration Page 1’ screen, touch the ‘Lightbar
Configuration’ button.
2. The ‘Lightbar Configuration’ screen displays.
3. To change the offset distance for an LED, touch the LED number (or
the bar below it) and a box will appear around that number, along with
arrows underneath it. Press the right or left arrow to increase or
decrease the offset amount. Press OK when you are done setting the
offsets.
Helpful Hint: Selecting the “Reverse LED Direction”
option will reverse the on-board and external lightbar
LED’s, so that you will need to turn away from the
LED’s instead of towards them.
To Next Page
Loading...
