Need help?Do you have a question about the RAWLINK 12108 and is the answer not in the manual?
Guidance on reading instructions for optimal use of the garage door opener.
Specifications including voltage, power rating, and maximum door dimensions.
Important safety warnings regarding exposure to water and installation on the same door.
Unpack and unfold the rail, then set couplings around the joints.
Fit the motor casing to the rail using U brackets and screws, ensuring correct orientation.
Install ceiling, wall, door brackets, and lifting arm according to diagrams.
The door opener must be programmed before use. Connect to mains electricity.
Configure the 'open door' and 'closed door' positions using the control panel.
Test resistance and adjust tolerance via remote control for optimal performance.
Follow manual procedure to register remote controls for door operation.
Hold S button down until display is blank to cancel a registered remote.
Use top button for open/close, bottom button for light control.
Pull cord attached to rider in rail to release brake during power failure.
Use menu 4 to adjust resistance levels for door operation.
Use menu 5 to select remote control number for controlling multiple doors.
Use menu 6 to enable or disable the audible alarm function.
Use menu 7 to set the time delay for automatic door closure.
Use menu 8 to enable or disable maintenance reminders.
Press + to select menu 1, hold P until '0' appears to save all settings.
Brush or wipe surfaces. Lubricate moving parts if noises occur.
Guidance on resolving common problems like door not moving or error codes.
Statement of conformity with relevant EU standards and directives.
Details on environmentally friendly manufacturing and substance compliance.
Information on manufacturing location, importer, and copyright.
General| Brand | RAWLINK |
|---|---|
| Model | 12108 |
| Category | Gate Opener |
| Language | English |
To Next Page