12
installer to check the floor warming system
installation. The set temperature can be adjusted
by using +/- keys.
2. 30min < Time < 2hours [from1.6h to 0.1h]:
The thermostat doesn’t take into account the set
temperature. But during this period, the thermostat
can power on and off the floor warming system to
adjust its regulation parameters.
If there is a main power supply loss during this learning
period (main switch off or power supply failure), the
thermostat will restart the learning function.
At the end of this learning function, the thermostat is
automatically calibrated (adapted to the load linked to
the thermostat):
Internal offset
Compensation
This function will run at every factory reset of the
thermostat.
4.2. Optional functions
4.2.1 Activating Heat booster < >
This function is used for temporary increase of the floor/
room temperature by 5°C.
Push the confirmation button <
> for 3 sec. The current
set temperature will increase by 5°C for 2 hours and this
increased temperature is shown on the display. Automatic
reverts to the set temperature after 2 hours or if the
confirmation button is pushed again for 3 sec. within the 2
hour period.
To Next Page
Loading...
