Raycus RFL-C300L User Manual

Wuhan Raycus Fiber Laser Technologies Co., Ltd
User Guide of Global Version 2000 W CW laser
Raycus User Guide | Common Alarms and solutions
47
50
Table 12 Error instructions and possible solutions
Alarm message
Error instructions and possible solutions
System Timer
Alarm
Instruction:
Internal clock abnormal.
Solutions:
When this alarm occurs, please contact Raycus directly.
Laser On Button
Alarm
Instruction:
This alarm occurs when the light exit button on the front panel
of the laser has been pressed before powering on.
Solutions:
When this alarm occurs, please power off the laser and make
the light enable button pop up, and then power on the laser
again to cancel the alarm. If the alarm continues to occur,
please contact Raycus.
Inter Lock Alarm
Instruction:
Occurs when the laser Interlock is disconnected.
Solutions:
Short the Interlock pins. If this error continues to occur, please
contact Raycus.
Current Driver
Alarm
Instruction:
Internal constant current driver is error.
Solutions:
Restart the Device. If this error continues to occur, please
contact Raycus.
Laser Out Alarm
Instruction:
The laser will get this alarm when it can not detect any laser
light signal. Laser out alarm occurs only when the laser is
emitting light
Solutions:
Restart the Device. If this error continues to occur, please
contact Raycus.
Laser Power Alarm
Instruction:
The alarm is generated when the emission of the laser cannot
reach the set value. Power alarm occurs only when the laser is
emitting light.
Solutions:
Restart the Device. If this error continues to occur, please
contact Raycus.
ACDC1 Alarm
Instruction:
AC/ DC1 Alarm. Laser power supply out of work or sudden
power disconnect of the power supply system may cause the
alarm.

Raycus RFL-C300L Specifications

General

Brand	Raycus
Model	RFL-C300L
Category	Measuring Instruments
Language	English