14
ST30 Depth Operation and Installation Handbook
Chapter 5: Operation
The ST30 Depth leaves the factory set to:
• display depth in feet
• with the deep and shallow alarms switched off
• in master mode
These settings can be changed in calibration (see section 6.1).
When the ST30 Depth is switched on, the instrument will display current
water depth in the units set up in calibration.
Feet
SHALLOW
DEEP
MINIMUM
OFFSET
D643
Note:
The trend arrows ▲ decreasing ▼ increasing, shown in the above
display, indicate whether the trend is towards deep or shallow water.
5.1 Display Key
Each press of Display cycles the following menu:
• Shallow Alarm Setting
• Deep Alarm Setting
• Minimum Depth
• Offset (Keel or Waterline)
A further press of Display will return the unit to current depth. The
display always returns to current depth after 8 seconds.
DISPLAY
TM
DEPTH
SHALLOW
DEEP
MINIMUM
OFFSET
Feet
D644
To Next Page
Loading...
