Chapter 3: Operation 3-3
PLACE
WAYPOINT
MOVE CURSOR, "ENTER"TO PLACE
WAYPOINT, "CLEAR" TO QUIT
2. Place the cursor in the required position on the chart and press ENTER to
place the waypoint. The waypoint is added to the waypoint list and named
using the next available number.
The waypoint functions remain displayed so that you can place further
waypoints.
If required, use EDIT WAYPOINT to name the waypoint as described in
Editing Waypoints below.
3. When finished placing waypoints, press CLEAR.
ä
To place a waypoint at the vessel’s position:
1. Select PLACE WPT AT VESSEL.
A new waypoint is placed at the vessel’s current position.
ä
To place a waypoint using the Waypoint List:
1. Select WAYPOINT LIST . The Waypoint List and associated functions are
displayed:
2. Select MAKE NEW WAYPOINT.
The waypoint is placed at the current vessel position or, if a GPS fix is not
available, the cursor position. The new waypoint is added to the Waypoint
List and named with the next available number.
To return to chart mode, press CLEAR twice.
To Next Page
Loading...
