Raymarine DSM30 - E Series System Configuration; C Series System Configuration

Chapter 1: DSM Installation 19
When used in a multiple display system, connect the DSM to the SeaTalk
hs
Network Switch.
Configuring an E Series System - Multiple Displays
Configuring C Series Displays
The C Series system uses cables with a round 4-pin twist-lock network connector.
A 3m-long C Series cable is included with your sounder module and is also
available in a 10 m length (Raymarine part number E65011). The display cable
attaches to the 4-pin male connector labelled “HSB2”on the connector panel of
the sounder module.
Configuring a C Series System
E Series Display
E Series Display
DSM
SeaTalk
hs
Network Switch
E55058
SeaTalk
hs
Cable
SeaTalk
hs
Cable
SeaTalk
hs
Cable
D9604-1
C Series Display
Sounder Module
4-pin to 4-pin C Series Cable
D9605-1