18 DSM300 Operation with PLUS Series Displays
2.6 Operating Modes
Depending on the types of equipment you have connected, up to four full-screen
modes – sonar, chart, radar, and data log are available. You select the operating
mode using the DISPLAY key.
You can also set Windows On to split the display into two half-screen windows
(horizontal or vertical) to show supplementary data, or to display sonar and chart
or radar simultaneously.
Horizontal Half-Screen Window Options
Using horizontal half screens, the main operating mode is displayed in the upper
window; you choose what is displayed in the lower window. The following
information, if available on your system, can be shown:
Vertical Half -Screen Window Options
This option splits the sounder vertically. The left hand window displays data
boxes; there are three different sets of data (A, B, and C) that you can select for
display. The following information is available only in Sonar Mode:
Note:
Receiving and displaying position data requires a GPS connected to your system.
Table 2-1: Horizontal Half-Screen Window Options
Full-screen
mode Horizontal Half-Screen Window Options
Sonar Mode Course Deviation Indicator (CDI), Bearing and Distance
Indicator (BDI), Depth/Temp graph, Chart plotter, Radar
Chart Mode CDI, BDI, Navigation Data (databoxes), Radar, Sonar
Radar Mode CDI, BDI, Navigation Data, Chartplotter, Sonar
Data Log Mode Half-screens not available
Table 2-2: Vertical Half-Screen Window Options
Full-screen
mode Vertical Half-Screen Window Options
A Temperature, Speed, Depth
B Position (latitude and longitude), Course Over Ground
(COG), Speed Over Ground (SOG), Depth
C Waypoint Range and Bearing, COG, SOG, Depth
To Next Page
Loading...
