32 DSM300 Operation with PLUS Series Displays
The changes do not take effect until after ENTER is pressed. Consult your NMEA
instrumentation documentation to determine which strings should remain ON.
Note:
The DSM300 outputs the same depth value for DBT and DPT, regardless of the
Depth Offset value in Sonar Setup.
Cursor Echo
You can set up an integrated system so that radar and chartplotter displays
connected via SeaTalk can display each other’s cursors.
Cursor echo functions so that you can display a chart cursor on the radar picture,
or a radar cursor on the chart picture (you cannot display a remote radar cursor in
a radar window nor can you display a remote chart cursor in a chart window).
When the appropriate options are switched on, each display shows its own cursor,
plus the cursor of the other display with appropriate cursor text (RDR or CHRT) to
indicate its origin. This means that you could move the cursor over a target on the
radar display and check the identity of the target by looking at the radar cursor
position on the chartplotter.
Press the CURSOR ECHO soft key to display the cursor transfer soft keys. The
following options can be toggled ON or OFF:
RTE Routes
TTM Tracked Target Message
VHW Water Speed and Heading
VLW Distance Travelled through the Water
WPL Waypoint Location
GGA Global Positioning System Fix Data
GLL Geographic Position – Latitude/Longitude
RMA Recommended Minimum Specific Loran-C Data
RMC Recommended Minimum Specific GPS/TRANSIT
Data
VTG Course Over Ground and Ground Speed
ZDA Time and Date
Table 3-2: NMEA Sentences
Sentence Meaning
To Next Page
Loading...
