mn100 Digital Display
22
www.raymarine.com
SETUP ALARMS - Alarms Chapter
In each case press the button quickly to edit, press the or
to change values and press the button quickly to save the
entered value. In the case of On/Off selection the button will toggle
the setting On and Off.
S11 Shallow Water Alarm
Sets the shallow depth at which the display will alarm.
The options are: OFF and 0.0 to 25.0 feet (0.0 to 7.6 metres)
(0.0 to 4.1 fathoms).
Values are displayed in the previously selected units (see
page 21 -s7 to select units) and are all subject to any keel or
waterline offset added (see page 29 section 4.1 to set an offset).
This alarm sounds as the depth passes below the set value and NOT as
the depth increases past this value.
S12 Deep Water Alarm
Sets the deep depth at which the display will alarm.
The options are: OFF and 0.0 to 250 feet (0.0 to 76.2 metres)
(0.0 to 41.6 fathoms). Values are displayed in the previously
selected units (see page 21 -s7 to select units) and are all
subject to any keel or waterline offset added (see page 29
section 4.1 to set an offset).
This alarm sounds as the depth increases past this value or decreases
past this value.
S13 High Wind Alarm
Sets the wind speed at which the display will alarm.
The options are: OFF and 0.0 to 100 knots (0.0 to 51.4 m/s).
Values are displayed in the previously selected units (see
page 21 -s8 to select units).
This alarm sounds as the wind speed increases past the set
value and NOT as it decreases past this value.
S14 Cross Track Error Alarm
Sets the display to alarm if a Large Cross Track Error Alarm
is issued by the GPS.
The options are: On/Off.
To Next Page
Loading...
