Rotary Drive - Installation Guide 5
Installation instructions
Parts required
To install this drive you will need:
• Parts supplied:
• rotary drive
• mounting foot
• spacing shims (x3)
• Additional parts:
• suitable securing bolts and lock washers/lock nuts (see
page 9)
• suitable sprockets and grub screws for drive and steering
system (see page 9)
• thread-locking compound
• suitable drive chain (see page 9)
• suitable cable and electrical connectors for the drive motor
and clutch (see page 13)
Note: Make sure you have obtained these additional parts before you
start installation.
Other information (applies to Types 1 and 2)
protected for use in engine compartments
CE approvals - conforms to:
89/336/EC (EMC), EN60945:1997
94/25/EC (RCD), EN28846:1993
Table 1: Drive specifications (contd)
To Next Page
Loading...
