Chapter 4: Calibration
19
bidata
depth speed
depth
speed
6 sec
REPEATER
VERSION
d
D5041-1
Software version
Displays the Bidata software version.
Repeater
The Bidata can be used as a master instrument connected directly to the
transducer, or, alternatively, as a repeating unit displaying speed and
depth information from another instrument.
Press speed to toggle between MASTER (R0) and REPEATER (R1)
operating modes.
In repeater mode:
• You cannot enter basic calibration.
• You cannot view or adjust alarms or offsets, or carry out log
calibration.
Saving intermediate calibration
Press and hold depth and speed for 2 seconds.
Exit intermediate calibration without saving
Press depth and speed together momentarily.
075_4c04.p65 11/04/01, 11:2719
To Next Page
Loading...
