20 ST60 Graphic Display Operating Guide
Setting units
With the Units setup screen displayed, use the button to move to each data
type in turn and for each, use the
track or reset button to select the required
unit.
NMEA OUT on/off
The NMEA OUT on/off screen enables you to set which function the NMEA
OUT connector provides. This is either:
• NMEA data out.
or
• Alarm signals for the Auxiliary Alarm.
If want to output NMEA data, use the track or reset button to select ON.If
you want to output alarm signals to the Auxiliary Alarm, select OFF.
Auxiliary Alarm select
Use the ALARM DRIVE screen to determine which alarms you want to sound at
the Auxiliary Alarm.
Note: The NMEA OUT function must be OFF, to enable the Auxiliary Alarm
to be used.
Use the track or reset button to set the ALARM DRIVE OFF, if you do not want
any alarms to sound at the Auxiliary Alarm. Otherwise, set it ON .
If you have set the ALARM DRIVE ON, use the button to move to each alarm
in turn and for each, use the
track or reset button to either enable (✓)or
disable (✘) the alarm.
Pilot pop-up
Use the track or reset button to set the PILOT POPUP either ON or OFF, as
required.
Instrument configuration
You can streamline the operation of the instrument by defining which pages
are available for display on a day-to-day basis, and switching off pages you
do not wish to see.
81226_1.book Page 20 Wednesday, November 19, 2003 9:53 AM
To Next Page
Loading...
