10 ST60 Graphic Display Operating Guide
Setting up Favorite pages
As there are seven Favorite pages, you may like to use these to display data
from each of the other chapters. So for example, on Favorite page 1, you
could show selected data from the Depth chapter, Favorite page 2 could show
selected Speed data, and so on.
To setup the data you want on each Favorite page:
1. With the FAVORITE chapter displayed, select the page you want to set up.
2. Hold down the track and reset buttons for approximately 2 seconds, to
enter the Favorite page setup mode.
3. Use the reset button to show the format you want, i.e. single element,
dual element, triple element or quad element. One element is highlighted
(white text on a black background), to show that is selected for adjust-
ment.
4. If you have chosen a multi-element page, use the track button to move
the highlight to the page element you want to set up.
5. Use the button to cycle to the data you want.
6. If you want to set up another element on this page, repeat steps 4 and 5.
7. Hold down the track and reset buttons for approximately 2 seconds, to
leave the Favorite page setup mode.
8. Repeat the above procedure for all Favorite pages you want to set up.
Refer to How can I customize my display? later in this chapter, for details of
how to set up:
• How many Favorite pages are displayed.
• Whether Favorite pages roll around automatically or you select them
manually.
Single-element Favorite page
Can be set to show any other
page, including rolling road and
graphs
Each element can be set to show
any available data, except rolling
road and graphs
Typical multi-element Favorite page
D6480-1
81226_1.book Page 10 Wednesday, November 19, 2003 9:53 AM
To Next Page
Loading...
