To Next Page

To Previous Page

Safety Instructions

12 Rev. G Nov/2015 MI3

The instrument can be equipped with a Class 2 laser. Class 2 lasers shine only within the

visible spectrum at an intensity of 1 mW. Looking directly into the laser beam can

produce a slight, temporary blinding effect, but does not result in physical injury or

damage to the eyes, even when the beam is magnified by optical aids. At any rate, closing

the eye lids is encouraged when eye contact is made with the laser beam. Pay attention to

possible reflections of the laser beam. The laser functions only to locate and mark surface

measurement targets. Do not aim the laser at people or animals.

To prevent possible electrical shock, fire, or personal injury follow these guidelines:

 Read all safety Information before you use the product.

 Use the product only as specified, or the protection supplied by the product can

be compromised.

 Carefully read all instructions.

 Do not use and disable the product if it is damaged.

 Do not use the product if it operates incorrectly.

 Make sure the ground conductor in the mains power cord is connected to a

protective earth ground. Disruption of the protective earth could put voltage on

the chassis that could cause death.

 Replace the mains power cord if the insulation is damaged or if the insulation

shows signs of wear.

 Use in 110/230 VAC electrical systems can result in electrical hazards and

personal injury, if not properly protected. All instrument parts supplied by

electricity must be covered to prevent physical contact and other hazards at all

times.

 The system integrator is responsible for the final safety of the system.

RayTek MI3 User Manual

Questions and Answers: