3
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
BEFORE YOU BEGIN
Remove contents from box and check parts against parts diagram found on page 15. Remove the separators that
protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint or
dents that may have occurred during shipping. Because the DXT Electric Drift Trike was partially assembled and
packed at the factory there should not be any problems, even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly. Two (2) person assembly recommended.
Allow up to 12 hours for charge (see page 7 for charging information).
WARNING: DO NOT
USE NON-RAZOR PRODUCTS
WITH YOUR DXT ELECTRIC DRIFT
TRIKE. The DXT Electric Drift
Trike has been built to certain
Razor design specifications. The
original equipment supplied at
the time of sale was selected
on the basis of its compatibility
with the frame, fork and all
other parts. Certain aftermarket
products may not be compatible
and will void your warranty.
WARNING: Safety flag
is intended to increase rider’s
visibility to others. Do not bend
excessively (flag can break if over
stressed) nor remove from seat
when riding.
Required Tools
Two (2) 5 mm Allen Wrenches
6 mm Allen Wrench
13 mm Wrench Spoke Tensioner
Box Contents:
• DXT Electric Drift Trike
• Flag
• Charger
• Tools
• Owner’s Manual
Product ID Locations:
See locations to the left
1. Frame (underneath unit)
2. Front Fork
3. Charger
4. Box - Side of UPC (not shown)
Front Wheel
Assembly
Charger
(Note: Charger design may
vary from one shown)
Rear Wheels
Twist Grip Throttle
Brake Lever
Battery Box
Seat
Flag
3
2
1
L
R