6
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual.
Attaching Flag
1 Assemble flag as shown 2 Insert flag into fixed hole located on seat.
Inflating the Tires
The tires are inflated when shipped, but will invariably lose some pressure between the point of manufacturing and
your purchase. Inflate the tires to the correct PSI before first time use.
Periodically check the tires. Reinflate when needed.
1 Using a bicycle tire pump equipped for a Schrader valve, inflate the
tires to the PSI indicated on the sidewall of the tire.
WARNING:
Do not use the DXT Electric Drift
Trike for the first time until you have
inflated the tire to the correct PSI.
Failure to do so may damage your
DXT Electric Drift Trike and will void
your warranty.
WARNING:
Do not over inflate, as this could
damage the tires or wheels.
Note: The pressurized air supplies
found at gasoline stations are
designed to inflate high-volume
automobile tires. If you decide to
use such an air supply to inflate
your tire, first make sure the
pressure gauge is working, then
use very short bursts to inflate to
the correct PSI. If you inadvertently
over-inflate the tire, release the
excess pressure immediately.
ASSEMBLY AND SET-UP
To Next Page
Loading...
Need help?
General
