RC-Plus PLUS POWER 80 - Initial Parameter Setup Guide; Setting Lithium Battery Voltage Type

11
INITIAL PARAMETER SET UP
It will be operated with the default value of the essential user settings when it is connected to a 12V
battery for the first time. The screen displays the following information in sequence and the user can
change the value of parameter on each screen.
When you are willing to alter the parameter value in the program, press Start/Enter key to make it
blink then change the value with INC or DEC key. The value will be stored by pressing Start/Enter
key once.
The screen displays the nominal voltage of Lithium battery.
There are three kinds of Lithium battery; LiFe(3.3V),Lilo(3.6V)
or LiPo(3.7V). This is very important so you have to check the
battery carefully and set it up correctly. If it is different from
correct value the battery can explode during charge process.
It recognise the cell count of Lithium battery automatically at
the beginning of charge or discharge process to avoid from
erroneous setting by user. But deeply discharged battery can
be perceived incorrectly. To prevent the error, you can set the
time term to verify the cell count by the processor. Normally,
10 minutes are enough to perceive the cell count correctly.
For the battery of larger capacity, you may extend the time
term. But if you set the time term too long for the battery of
smaller capacity, the charge or discharge process can be
finished within the time term with the erroneous cell count.
This may cause the fatal result. If the processor recognises
the cell count incorrectly at the beginning of charge or dis-
charge process, you may extend the time. Otherwise, you
had better use with the default value.
-
7
-
5.Initial Parameter set up (Users' set up)
It will be operated with the default value of the essential user settings when it
is connected to a 12V batttery for the first time.The screen displays the following
information in sequence and the user can change the value of parameter on each
screen.
When you are willing to alter the parameter value in the program, press Start/
Enter key to make it blink then change the value with INC or DEC key. The value will
be stored by pressing Start/Enter key once.
The screen displays the nominal voltage of Lithium
battery. There are three kinds of Lithium battery;
LiFe(3.3V),Lilo(3.6V) or LiPo(3.7V). This is very
important so you have to check the battery carefully
and set it up correctly. If it is different from correct
value the battery can explode during charge process.
It rec ognise the cell count of Lithium battery
automatically at the beginning of charge or discharge
process to avoid from erroneous setting by user. But
deeply discharged battery can be perceived incorrectly.
To prevent the error, you can set the time term to verify
the cell count by the processor. Normally, 10 minutes
are enough to perceive the cell count correctly. For
the battery of larger capacity, you may extend the
time term. But if you set the time term too long for the
battery of smaller capacity, the charge or discharge
process can be finished within the time term with the
erroneous cell count. This
may cause the fatal result.
If the processor recognises the cell count incorrectly at
the beginning of charge or discharge process, you may
extend the time. Otherwise, you had better use with
the default value.